ALIGNMENT PUSH ROLLERS

ALIGNMENT PUSH ROLLERS

Our very heavily built alignment rollers are built to last.

The outside roller is made with 3 ½” UHMW rollers spinning on a 2” solid stainless-steel shaft, when transitioning from angled to strait we use a 2” thick UHMW block, making it impossible for the wheels to contact any hard surfaces that will damage the wheels.

Inside rollers are 2” stainless steel pipe spinning on 7/8” stainless steel shaft with UHMW bushings and cradled in a 2 ½” x 2 ½” x ½ thick steel framework.

These rollers are made to push the wheels centered to the conveyor while the tires are still on the bottom alignment rollers, then car can roll forward 8” releasing side load on tire while it rolls off bottom rollers onto the conveyor. This greatly eliminates snapping and pinching that can damage tires.

Alignment Push Rollers can be built in custom sizes.

ALIGNMENT PUSH ROLLERS GALLERY

Looking for car wash equipment built to last? And car wash maintenance solutions you can trust?

Give us a call at (801) 372-3249 or email dave@davesvictoryfab.com today!